Hello,
I use a QIDI X-plus 3 printer with QidiSlicer and when I slice whatever the part, the inside filling is incomplete?
For example, photo of the 727's left aileron.
Do yo have a solution?
top of page
bottom of page
Hello,
I use a QIDI X-plus 3 printer with QidiSlicer and when I slice whatever the part, the inside filling is incomplete?
For example, photo of the 727's left aileron.
Do yo have a solution?
When I select vase mode, Qidi slicer automatically deselects the thin walls option.
hello
I solved the problem by changing the value slice gap closing radius to 0.001
Even with this on it still ignores internal walls. In prusa slicer I can't detect internal walls. On anycubic slicer it just doesn't print anything and with cura it drops below the level of the bed and then jams against the bed
Not getting anywhere
Im having the same problem. Tried several slicers and eventually came across this setting in cura called experimental. Change slicing tolerance to Exclusive and the internal wall structure appears. I'm just attempting a print now.
Thanks Dean,
You're right, the software instantly deactivates this option if I select the vase mode.
I solved the problem by changing the GAP radius value as explained in a previous post about Bambu studio, which by the way is very similar to qidi slicer.
Thanks again for your advice Dean.
Karl
I use cura but have the same problem if I do not click the "print thin walls" on my AnyCubic it is called "detect thin walls" Make sure this feature is turned on otherwise the thin internal walls are ignored by the slicer