RC 3D Printing Forum

Hey Troy! Just wanted to say I love your 727 design—I’ve already printed four of them! Incredible work. I’ve been thinking about a potential redesign idea: what if you scaled it up a bit to fit one 90mm EDF or even two smaller fans side-by-side, aiming for a total wingspan around 70 inches? It’d be amazing to see this with working flaps and maybe even semi-scale retractable landing gear. The larger scale and improved wing loading would probably make it fly even smoother and more stable—especially with that iconic 727 vibe. Just thought I’d throw the idea your way. Keep up the awesome work!

With the arrival of Bambu Studio 2.0.1.50 the printer setting names are different. Would it be possible to update the printer settings page to show the new nomenclature? With screen shots too if possible please. I know I'm not interpreting one of the settings correctly. I purchased the 727 model but the male ends are printing with a base which doesn't allow for any shrink and dont quite fit into the female end which is slightly smaller.

I'm using E sun foaming PLA and I've figured out most of the planes sections, but on wing R3 and L3 that is the outer wing tips. the wing tips are printing with holes in the surface, I've maxed out variable layer height. I have tried printing the wing in different places and directions on the build plate. I can close up the holes, but I have to increase the top shell layers and that turns off vase mode which increases the weight of the part. Any help would much appreciated. some of the failures